PLANET WGSW-52040 - Manual (Page 172)

Notice: Dynamic VLAN needs to associate with Hybrid attribute of the ports to work, so the
ports that may be added to a dynamic VLAN must be configured as Hybrid port.
20.6.2 Dynamic VLAN Configuration
Dynamic VLAN Configuration Task Sequence:
1. Configure the MAC-based VLAN function on the port
2. Set the VLAN to MAC VLAN
3. Configure the correspondence between the MAC address and the VLAN
4. Configure the IP-subnet-based VLAN function on the port
5. Configure the correspondence between the IP subnet and the VLAN
6. Configure the correspondence between the Protocols and the VLAN
7. Adjust the priority of the dynamic VLAN
1. Configure the MAC-based VLAN function on the port
Command Explanation
Port Mode
switchport mac-vlan enable
no switchport mac-vlan enable
Enable/disable the MAC-based VLAN
function on the port.
2. Set the VLAN to MAC VLAN
Command Explanation
Global Mode
mac-vlan vlan <vlan-id>
no mac-vlan
Configure the specified VLAN to MAC
VLAN; the “no mac-vlan” command
cancels the MAC VLAN configuration of
this VLAN.
3. Configure the correspondence between the MAC address and the VLAN
Command Explanation
Global Mode
mac-vlan mac vlan Add/delete the correspondence between
20-94