PLANET WGSW-52040 - Manual (Page 371)

dot1x guest-vlan
no dot1x guest-vlan
Set the guest vlan of the specified port; the
no command is used to delete the guest
vlan.
dot1x portbased mode single-mode
no dot1x portbased mode single-mode
Set the single-mode based on portbase
authentication mode; the no command
disables this function.
3) Configure expanded 802.1x function
Command Explanation
Global Mode
dot1x macfilter enable
no dot1x macfilter enable
Enables the 802.1x address filter function in the switch; the
no command disables the 802.1x address filter function.
dot1x macbased
port-down-flush
no dot1x macbased
port-down-flush
Enables this command, when the dot1x certification
according to mac is down, delete the user who passed the
certification of the port; The no command does not make
the down operation.
Command Explanation
Port Mode
dot1x port-method {macbased |
portbased | userbased {standard |
advanced}}
no dot1x port-method
Sets the port access management method;
the no command restores MAC-based
access management.
dot1x max-user macbased
no dot1x max-user macbased
Sets the maximum number of access users
for the specified port; the no command
restores the default setting of allowing 1
user.
dot1x max-user userbased <number>
no dot1x max-user userbased
Set the upper limit of the number of users
allowed accessing the specified port, only
used when the access control mode of the
port is userbased; the no command is used
to reset the limit to 10 by default.
42-150