TA Triumph-Adler DC 2435 - Manual (Page 470)

Troubleshooting
12-4
Paper often jams. Is the paper loaded
correctly? Load the paper correctly. 2-28
— Change the orientation in which the
paper is positioned. xxxvii
2-28
2-35
Is the paper of the supported
type? Is it in good condition? Remove the paper, turn it over, and
reload it. 2-28
Is the paper curled, folded or
wrinkled? Replace the paper with new paper. 2-28
Are there any loose scraps or
jammed paper in the
machine? Remove any jammed paper. 12-21
Printouts have black
lines. Are the slit glass and the
Dual scanning area dirty? Clean the slit glass and the Dual
scanning area. 11-16
Printouts are wrinkled
or curled. Is the paper separator of the
paper feed unit dirty? Clean the paper separator. 11-19
Is the paper damp? Replace the paper with new paper. 2-27
— Change the orientation in which the
paper is positioned. xxxvii
2-28
2-35
Cannot print. Is the machine plugged in? Plug the power cord into an AC
outlet. —
Is the machine powered on? Turn on the main power switch. 3-2
Are the printer cable and
network cable connected? Connect the correct printer cable
and network cable securely. 2-3
Was the machine powered
on before the printer cable
was connected? Power on the machine after
connecting the printer cable. 2-3
Is the print job paused? Resume printing. 8-3
Documents are
printed improperly. Are the application software
settings at the PC set
properly? Check that the printer driver and
application software settings are
set properly. —
Cannot print with USB
memory.
USB memory not
recognized. Is the USB host blocked? Select [Unblock] in the USB host
settings. 9-107
— Check that the USB memory is
securely plugged into the machine. —
Symptom Checkpoints Corrective Actions
Reference
Page