TA Triumph-Adler DC 2435 - Manual (Page 200)

Copying Functions
4-44
Maximum Number of Repeat Copy Jobs Retained
You can use the procedure below to change the maximum number of copy jobs that can be retained in the
document box.
Use the procedure below to change the maximum number of copy jobs retained.
1 Press the System Menu key.
2 Press [Document Box/Removable Memory] and
then [Next] of Job Box.
3 Press [Change] of Repeat Copy Job Retention.
4 Use the [+] or [-] key to enter the maximum
retention number.
You can also enter the number from the numeric
keys.
A number between 0 and 50 can be entered as the
number of retained jobs.
NOTE: If you enter a value of 0 (zero), you cannot use
the Repeat Copy function.
5 Press [OK].
DP Read Action
Set the operation when a document is scanned from the document processor. The table below shows the
available settings.
NOTE: The optional document processor is required.
Cannot be used when set to [On] in Document Guard on page 9-108.
Use the procedure below to set a DP Read Action
1 Press the Copy key.
2 Place the original.
3 Press [Advanced Setup] and then Press [DP Read
Action].
4 Select [Speed Priority] or [Quality Priority].
5 Press [OK].
6 Press the Start key. Copying begins.
Document Box/Removable Memory - Repeat Copy Job Retention
Set the maximum number of repeat copy jobs to retain.
Use [-]/[+] or the numeric keys to enter a number.
*Set this number to 0 to not retain any jobs.
(0 - 50)
32
Cancel OK
Status
job(s)
10/10/2010 10:10
Item Detail
Speed Priority Priority given to scanning speed.
Quality Priority Priority given to image quality.