TA Triumph-Adler DC 2435 User Manual
Page 382
Default Setting (System Menu)
9-84
Group
Compile two or more contacts into a group. Designations in the group can be added at the same time. When
adding a group, a maximum of 500 groups can be added in the Address Book.
NOTE:
Before adding a group in the Address Book, the contacts to be included in the group must be added
first. Up to 100 destinations for the e-mail, 500 destinations for the FAX, and a total of 10 destinations for the
FTP and SMB can be registered per group.
Use the procedure below to register a group.
1
Press the System Menu key.
2
Press [Edit Destination], [Add/Edit] of Address Book, [Add], [Group] and then [Next].
3
To specify the address number, press [Change] in Address Number.
4
Use [+]/[-] or the numeric keys to enter an address number (1 to 2500).
To have the number assigned automatically, set "0000".
NOTE:
Address Number is an ID for a group. You can select any available number out of 2,000 numbers for
contacts and 500 numbers for groups.
If you specify an address number that is already in use, an error message appears when you press [Save] and
the number cannot be registered. If you set "0000" as the address number, the address is registered under the
lowest available number.
5
Press [OK]. The Add Group screen reappears.
6
Press [Change] of Name.
7
Enter the group name displayed on the Address Book not more than 32 characters.
NOTE:
Refer to the Character Entry Method on page Appendix-9 for details on entering characters.
8
Press [Member].
9
Press [Add].
10
Select destinations (contacts) to add to the group.
NOTE:
Destinations can be sorted or searched by destination name or address number. Refer to Specifying
Destination on page 3-39 for Address List.
11
Press [OK].
If you have more destinations to add, repeat Steps 9 to 11.
12
Check if the selected destination was added to the group and press [Save]. Now the group is added to the
Address Book.
To register the registered address in a one-touch key, press [Yes] in the pop-up screen that appears after [Save]
is pressed.
NOTE:
To register a new One Touch Key, refer to Adding a Destination on One Touch Key (One Touch