HEIDENHAIN TNC 620 (34056x-04) Cycle programming - Manual (Page 60)

Using Fixed Cycles
2.4 Point tables
2
60
TNC 620 | User's Manual Cycle Programming | 5/2013
Hiding single points from the machining process
In the
FADE column of the point table you can specify if the defined
point is to be hidden during the machining process.
In the table, select the point to be hidden.
Select the
FADE column.
Activate hiding, or
Deactivate hiding.
Selecting a point table in the program
In the
PROGRAMMING AND EDITING mode of operation, select the
program for which you want to activate the point table.
Press the PGM CALL key to call the function for
selecting the point table.
Press the POINT TABLE soft key.
Enter the name of the point table and confirm your entry with the
END key. If the point table is not stored in the same directory as
the NC program, you must enter the complete path.
Example NC block
7 SEL PATTERN "TNC:\DIRKT5\MUST35.PNT"