HEIDENHAIN TNC 620 (34056x-04) Cycle programming - Manual (Page 264)

Cycles: Special Functions
12.3 PROGRAM CALL (Cycle 12, DIN/ISO: G39)
12
264
TNC 620 | User's Manual Cycle Programming | 5/2013
12.3 PROGRAM CALL (Cycle 12, DIN/ISO:
G39)
Cycle function
Routines that you have programmed (such as special drilling cycles
or geometrical modules) can be written as main programs. These
can then be called like fixed cycles.
Please note while programming:
The program you are calling must be stored on the
hard disk of your TNC.
If the program you are defining to be a cycle is
located in the same directory as the program you
are calling it from, you need only enter the program
name.
If the program you are defining to be a cycle is not
located in the same directory as the program you are
calling it from, you must enter the complete path, for
example
TNC:\KLAR35\FK1\50.H.
If you want to define a DIN/ISO program to be a
cycle, enter the file type .I behind the program name.
As a rule, Q parameters are globally effective when
called with Cycle 12. So please note that changes
to Q parameters in the called program can also
influence the calling program.