HEIDENHAIN TNC 620 (34056x-04) Cycle programming - Manual (Page 305)

Fundamentals 15.1
15
TNC 620 | User's Manual Cycle Programming | 5/2013
305
Cycle Soft key Page
408 SLOT CENTER REF PT.
Measuring the inside width of a slot,
and defining the slot center as datum 308
409 RIDGE CENTER REF PT.
Measuring the outside width of a
ridge, and defining the ridge center
as datum 312
410 DATUM INSIDE RECTANGLE
Measuring the inside length and
width of a rectangle, and defining the
center as datum 315
411 DATUM OUTSIDE RECTANGLE
Measuring the outside length and
width of a rectangle, and defining the
center as datum 319
412 DATUM INSIDE CIRCLE
Measuring any four points on the
inside of a circle, and defining the
center as datum 323
413 DATUM OUTSIDE CIRCLE
Measuring any four points on the
outside of a circle, and defining the
center as datum 328
414 DATUM OUTSIDE CORNER
Measuring two lines from the
outside of the angle, and defining the
intersection as datum 332
415 DATUM INSIDE CORNER
Measuring two lines from within the
angle, and defining the intersection
as datum 336
416 DATUM CIRCLE CENTER
(2nd soft-key level) Measuring any
three holes on a bolt hole circle,
and defining the bolt-hole center as
datum 339
417 DATUM IN TS AXIS
(2nd soft-key level) Measuring any
position in the touch probe axis and
defining it as datum 343
418 DATUM FROM 4 HOLES
(2nd soft-key level) Measuring 4
holes crosswise and defining the
intersection of the lines between
them as datum 345
419 DATUM IN ONE AXIS
(2nd soft-key row) Measuring any
position in any axis and defining it as
datum 349