HEIDENHAIN TNC 620 (34056x-04) Cycle programming User Manual
Page 21
TNC 620 | User's Manual Cycle Programming | 5/2013
21
7
Fixed Cycles: Contour Pocket........................................................................................................169
7.1
SL Cycles............................................................................................................................................... 170
Fundamentals......................................................................................................................................... 170
Overview................................................................................................................................................ 171
7.2
CONTOUR (Cycle 14, DIN/ISO: G37).................................................................................................. 172
Please note while programming:........................................................................................................... 172
Cycle parameters................................................................................................................................... 172
7.3
Superimposed contours...................................................................................................................... 173
Fundamentals......................................................................................................................................... 173
Subprograms: overlapping pockets........................................................................................................ 173
Area of inclusion.................................................................................................................................... 174
Area of exclusion................................................................................................................................... 175
Area of intersection................................................................................................................................176
7.4
CONTOUR DATA (Cycle 20, DIN/ISO: G120, software option 19)....................................................177
Please note while programming:........................................................................................................... 177
Cycle parameters................................................................................................................................... 178
7.5
PILOT DRILLING (Cycle 21, DIN/ISO: G121, software option 19).................................................... 179
Cycle run.................................................................................................................................................179
Please note while programming:........................................................................................................... 179
Cycle parameters................................................................................................................................... 180
7.6
ROUGHING (Cycle 22, DIN/ISO: G122, software option 19)............................................................ 181
Cycle run.................................................................................................................................................181
Please note while programming:........................................................................................................... 182
Cycle parameters................................................................................................................................... 183
7.7
FLOOR FINISHING (Cycle 23, DIN/ISO: G123, software option 19)................................................. 184
Cycle run.................................................................................................................................................184
Please note while programming:........................................................................................................... 184
Cycle parameters................................................................................................................................... 184
7.8
SIDE FINISHING (Cycle 24, DIN/ISO: G124, software option 19).................................................... 185
Cycle run.................................................................................................................................................185
Please note while programming:........................................................................................................... 185
Cycle parameters................................................................................................................................... 186