HEIDENHAIN TNC 620 (34056x-04) Cycle programming User Manual
Page 22
Contents
22
TNC 620 | User's Manual Cycle Programming | 5/2013
7.9
CONTOUR TRAIN (Cycle 25, DIN/ISO: G125, software option 19).................................................. 187
Cycle run.................................................................................................................................................187
Please note while programming:........................................................................................................... 187
Cycle parameters................................................................................................................................... 188
7.10
Programming Examples...................................................................................................................... 189
Example: Roughing-out and fine-roughing a pocket.............................................................................. 189
Example: Pilot drilling, roughing-out and finishing overlapping contours............................................... 191
Example: Contour train.......................................................................................................................... 193