Grass Valley DD35 Family v.3.1.5 - Manual (Page 65)

2. Panel Operation DD35 Production Switcher
2 – 31 Operating Instructions – Rev. 16 / 10.2001
2.6.3.1 Using FXLoop
t
Once the DVE installation (signal connection) is made, the FXLoop t is operated
in the following way:
D
In the M/E menu, use the softkey FXLoop to select the desired DVE. This set-
ting remains until changed.
D
In the Transition Panel, press and hold down the button Loop.
D
Select the component to loop (BGD-B, BGD-A, Key1, Key2). The indicator
Loop will light up for this component.
D
Release Loop
D
Now the pre-processed signals of the selected component is routed to the
DVE.
D
The FXLoop t now can be switched on and off by simply pressing Loop.
It is possible but not recommended to overwrite the selections made in the Transi-
tion Panel by making selections in the Pre-Processed Signal selection group of the
AUX Buses Panel. The resulting image may look peculiar.
2.6.3.2 Selecting a DVE effect
Once the DVE installation (control connection) is made, a DVE effect can be se-
lected in the following way:
D
In the Wipe Panel, push the delegation button of the desired DVE (DVE1 or
DVE2)
D
Press a wipe pattern selection button to select the effect. The top-left button will
select effect No=0. The bottom-right will select effect No=29.
Note: These are the default numbers. As an application setting it is possible
to make an assignment of the effects on the DVE to the 30 buttons.)
It is also possible to select an effect using the menu Remote DVE of the specific
DVE.
2.6.3.3 Using DVE transition
Once the DVE installation (signal connection) is made, the FXLoop t is operated
in the following way:
D
In the M/E menu, use the softkey FXLoop to select the desired DVE. This set-
ting remains until changed.
Once the DVE installation (signal and control connection ) is made, the DVE transi-
tion can be used like a wipe transition by doing the following: