Grass Valley DD35 Family v.3.1.5 - Manual (Page 211)

3. Menu Operation DD35 Production Switcher
3 – 59 Operating Instructions – Rev. 16 / 10.2001
3.7.4.2 Function Buttons
For details refer to section Introduction.
Press the associated button to highlight the mask (paint) signal on the preview
monitor. This function serves to paint the mask.
Note: In PVW mode, the paint mask is only represented as a 1-bit signal. If
you want to exactly position a mask with softness, simply switch on
the mask with the Mask on button in the Keyers panel.
Press the associated button to invert the mask signal. This means that, for exam-
ple, with a rectangular mask, not the inside but the outside of the rectangle is used
for masking.
Call the M/E Wipe Select menu.
To store or paint a mask, proceed as follows:
D
Select the signal to be stored or to paint with in the Mask store with Mask Bus,
Pattern1/Pattern2 or Key1/Key2.
D
To store a wipe signal or to paint, press Pattern1 or Pattern2. The desired wipe
pattern and the modification can be selected in the Wipe panel or Pattern Se-
lect menu.
D
For storing a texture, please refer to section Wipe menu.
D
To assign a key signal as a source to the paint store, press KEY1 or KEY2.
The required adjustments can subsequently be made in the Keyers panel.
Delegate
PVW
Invert mask
Pattern Select
Mask Store Source