Grass Valley DD35 Family v.3.1.5 - Manual (Page 58)

2. Panel Operation DD35 Production Switcher
2 – 24 Operating Instructions – Rev. 16 / 10.2001
Transition Type The Transition Type buttons permit selection of different types of transition:
To select a transition type, activate the next-transition button for the picture compo-
nent and then select a transition type with ADD, DVE, Mix, Wipe 1 or Wipe 2.
Transition Type
DVE Mix
Wipe
1
Wipe
2
Transition Type
Add Mix
Wipe
1
DVE
or
alternative
The selected transition type is indicated above the respective next-transition but-
ton.
Note: Please note that you can only change the transition type when the
transition procedure is finished, i.e. when an automatic transition has
been completed or the fader is in final position.
Add Add is used for a full additive mix of PGM and PST. The output level is internally
limited to 100%.
100%
PGM
PST
0%
Start Mid End
Note: Please note that this type of transition can only be used for back-
ground transitions.
Mix Mix enables a type of transition which performs a cross fading between the picture
signals selected with the next-transition keys.
Wipe (n) Wipe 1 and Wipe 2 enable a wipe transition with the signal of the respective wipe
generator 1 or 2.
For further information on the control of the wipe generator, please refer to the sec-
tion Wipe Panel.
Note: Please note that the wipe generators can be used simultaneously for
several applications which may interact.
Always use a wipe generator only for one function!