Grass Valley DD35 Family v.3.1.5 - Manual (Page 233)

3. Menu Operation DD35 Production Switcher
3 – 81 Operating Instructions – Rev. 16 / 10.2001
3.8.2.2 Function Buttons
For details refer to section Introduction.
Selecting Set Matrix delegates the respective controls to the digipots to modify the
selected wipe patterns. This function is active only in connection with matrix pattern
and if the Matrix modifier is activated.
Selecting Reset sets the Multi modifier to OFF and the Blocks to Small.
The following adjustments are possible:
Multi H Multi horizontal multiplication
V Multi vertical multiplication
H+V Multi multiplication in radial direction, only for closed
wipe patterns (e.g. circle)
OFF no multiplication
Blocks Small Blocks block size small
Large Blocks block size large
Selecting Set Aspect delegates the respective controls to the digipots to adjust the
aspect ratio of the wipe pattern if Aspect modifier is activated.
Selecting Reset sets the Aspect modifier to “normal”.
The following adjustments are possible:
H-Strch horizontal stretch
V-Strch vertical stretch
Ratio By clockwise or counter-clockwise rotation the
wipe pattern may be stretched horizontally and/or vertically.
Note: This function is not available for all patterns. See section 3.8.6. Please
note that in Stretch, a linear piece is inserted in the wipe pattern. With
Ratio the aspect ratio of height and width is changed. Please note also
that the width of the borders with Stretch and Ratio is different.
Delegate
Set Matrix
Set Aspect