Grass Valley DD35 Family v.3.1.5 - Manual (Page 188)

3. Menu Operation DD35 Production Switcher
3 – 36 Operating Instructions – Rev. 16 / 10.2001
Recall the single M/E Preset
Factory Preset Recall the factory preset
Operation Preset Recall the user defined operation preset. See below to store
the user defined operation preset.
All stop Press the associated button to stop or reset the
following functions:
D
stops all ongoing auto transitions
D
sets FTB to inactive (100%)
D
sets transition type to MIX
D
in non-layer mode:
– moves BGND transition to start position
– removes all keyers
– set Next Transition BGND
– resets Next Transition for all other components.
D
in layer mode
– moves all layers which are not in an end position into the
start position of the current direction
– sets Next Transition Layer A
– resets Next Transition for all other components.
D
This command does not
– influence matrix crosspoints
– stop TiM/E timeline play or TiM/E snapshot dissolve.
Press the associated button to change the TV standard of the respective M/E to
16:9 format. The format setting in the Config / E-Box / Global menu has a higher
priority. A change in the configuration menu set all M/E specific settings to the same
format!
For details refer to section Introduction.
Recall Preset
Format 16:9
Transfer M/E