Grass Valley DD35 Family v.3.1.5 User Manual

Page 124

2. Panel Operation

DD35 Production Switcher

2 – 90

Operating Instructions – Rev. 16 / 10.2001

2.15.3.4 Enabling and disabling bank mode

The Bank mode in the EXTRA panel permits access to a stored snapshot or time-
line with a single key (hotkey). The bank number is the tens digit of the register. The
hotkeys are the units digits of the register. The Bank mode may be enabled during
storing but this does not have any particular benefit.

Hold the Bank key down and select the desired bank with the numeric keypad. The
Bank key lights up. In the display a ”B” appears before the register number.

Example:

S N A P

B 0 5

S N 0 5 – – – –

Press the lighting Bank key.

2.15.3.5 Selecting a register during storing

During the storing of snapshots or timelines the register to be used for storage must
be selected. The procedure is the same for both cases.

However, the indication in the display differs.

for snapshots

STOR

for Timelines

EDIT

If the register number is to be taken over that was shown before the actuation
of the Store or Edit key, no further selection is necessary.

Note: During storing the contents of the register is overwritten!

If you wish to select the next free register, press the FREE key.

If you wish to select a particular register, enter a one- or two-digit number with
the numeric keypad. Errors can be deleted with Clear.

Note: Should the register be assigned, the contents is overwritten

during storing.

Enabling
Bank mode

Disabling
Bank mode