Grass Valley DD35 Family v.3.1.5 - Manual (Page 204)

3. Menu Operation DD35 Production Switcher
3 – 52 Operating Instructions – Rev. 16 / 10.2001
For details refer to section Introduction.
The Flat Matte 1 and Flat Matte 2 buttons serve to switch on Flat Matte1 or 2 so
that the desired colors can be adjusted.
Note: Please note that in case of unfavorable parameter settings only one
matte will be visible in Wash or MatteStore mode. In this case we rec-
ommend to switch over to the Flat mode to adjust the color.
The Hue control serves to adjust the color. The Chroma control serves to adjust
the color saturation (chrominance). The Luminance control serves to adjust the
desired brightness of the color.
Note: Please note that certain combinations of chrominance and luminance
values will cause illegal colors. For this reason, an automatic control
limits for instance the chrominance for defined luminance values.
If Color Limiter is on, you can easily check this be setting the Chroma
control to maximum and then turning the Luminance control slowly
to maximum; the chrominance will be reduced with increasing lumi-
nance values. If Color Limiter is off an ILLEGAL indication will light
up above the Hue bar.
The wash buttons serves to select a matte that is composed of a color wash be-
tween matte 1 and matte 2. If only the wash button lights up, it is possible to change
the color wash individually with the Softness, Position, and Angle controls.
For details refer to section Introduction.
Menu Lock
Fill Color Output:
Flat Matte 1
Flat Matte 2
Border Color Output:
Flat Matte 1
Flat Matte 2
Fill Color Output:
Border Color Output:
Wash
Digits