Comtech EF Data CSAT-5060 User Manual
Csat-5060
Table of contents
Document Outline
- CSAT-5060 Rev 1
- Table of Contents
- PREFACE
- Chapter 1. INTRODUCTION
- Chapter 2. SPECIFICATIONS
- Chapter 3. CONNECTOR PINOUTS
- Chapter 4. SYSTEM OPERATION
- 4.1 Turning On the CSAT
- 4.2 Configuring the CSAT
- 4.2.1 Frequency
- 4.2.2 Attenuation
- 4.2.3 Gain Offset
- 4.2.4 Mute Mode
- 4.2.5 Mute
- 4.2.6 Tx Amplifier
- 4.2.7 Channel Slope Adjust Mode
- 4.2.8 Channel Slope Adjust
- 4.2.9 Reference Frequency Adjust
- 4.2.10 External Reference Fault Logic
- 4.2.11 Cold Start Function
- 4.2.12 Auto Fault Recovery
- 4.2.13 LNA Current Source
- 4.2.14 LNA Current Calibration and Current Window
- 4.2.15 LNA Fault Logic
- 4.2.16 Redundancy Controller Auto/Manual
- 4.2.17 Redundancy Controller Toggle
- 4.2.18 Set Physical Address
- 4.2.19 Set Baud Rate
- 4.2.20 Set Date
- 4.2.21 Set Time
- Chapter 5. REDUNDANT SYSTEMS
- Chapter 6. REMOTE CONTROL
- Chapter 7. MAINTENANCE AND TROUBLESHOOTING
- Chapter 8. LNA INSTALLATION
- Chapter 9. CSAT-5060 +10 dBm Unit
- Appendix A. CSAT-5060 5 to 25 Watt INSTALLATION
- Appendix B. CSAT-5060 50-Watt INSTALLATION
- Appendix C. CSAT-5060 100W or 125W INSTALLATION
- CSAT-5060 Rev 1 Addendum A
- Addendum A. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
- Chapter 3. UPDATING FIRMWARE
- Appendix A. REMOTE CONTROL