Comtech EF Data CSAT-5060 - Manual (Page 221)

CSAT-5060 C-Band Transceivers Revision 1
Appendix A MN/CSAT5060.IOM
A–25
CSAT with Ethernet Remote Commands
Parameter
Type
Command Arguments Description of arguments Response to Command Query
Response to
query
SNMP Trap
Destination IP
Address 2
STB= 15 bytes,
Numerical
Command or Query.
Used to set the IP address of the first SNMP Trap
destination IP Address 2
where traps will be sent, in the form:
xxx.xxx.xxx.xxx is the IP addresss
Example: <1/STB=010.006.030.001
When not configured, returns >0001/STB=0.0.0.0
STB =
STB?
STB? STB=xxx.xxx.xxx.x
xx
See Note 2
SNMP
Trap Version
STV= 1 byte Command or Query.
SNMP Trap Version that will be used to send traps.
1=SNMP Trap Version 1
2=SNMP Trap Version 2
Example: <1/STV=0
STV =
STV?
STV? STV =x
See Note 2
SNMP
Write
Community
SWC= 20 bytes,
characters, no
spaces
Command or Query.
SNMP write community string. Empty string is not
allowed
Example: <1/SWC=private
SWC =
SWC?
SWC? SWC =x
See Note 2
SNMP
Enable
SNM= 1 byte Command or Query.
SNMP Enable.
0=Disabled
1=Enabled
Example: <1/SNM=0 SNM=
SNM?
SNM? SNM =x
See Note 2
SNMP
Authentication
Trap Enable
SNA= 1 byte Command or Query.
SNMP Authentication Trap Enable
0=Disabled
1=Enabled
Example: <1/SNA=0
SNA=
SNA?
SNA? SNA =x
See Note 2
Admin
Name
ADN= 10 bytes,
characters, no
spaces
Command or Query.
Admin Name for the telnet interface
Example: <1/ADN=comtech ADN=
ADN?
ADN? ADN=x
See Note 2
Admin
Password
ADP= 10 bytes,
characters, no
spaces
Command or Query.
Admin Password for the telnet interface
Example: <1/ADP=comtech ADP=
ADP?
ADP? ADP=x
See Note 2