Comtech EF Data CSAT-5060 - Manual (Page 96)

C-Band Transceiver Revision 1
CSAT-5060 5 to 25 Watt Installation MN/CSAT5060.IOM
A–6
Step Procedures
4 Position the Unistrut bracket (1) with pipe blocks (11) against the mounting pole,
slide the pipe blocks (11) until they contact the mounting pole. Ensure the pipe
blocks (11) are centered to the Unistrut bracket (1). Tighten the hardware.
5 Attach bracket (5, figure A-1) to the strap (4) using two nuts (10), two flat washers,
(7), and two split washers (8).
6 Place the assembly against the pole with the strap around the pole and trim the
strap to fit as shown in Figure A-5, using the tin snips. Attach bracket (3, figure A-
1) to the strap (4) using two nuts (10), two flat washers (7), and two split washers
(8).
7 Slide tensioner bracket (2) into channel of the Unistrut bracket (1). Place
assembly on the pole. Slide bracket (3) over bracket (2).
8 Place flat washer (7) and split washer (8), and nut (10) on bracket (2). Tighten nut
to secure the tension strap.
9 Slide two springnuts, (5, figure A-2) into channel of the Unistrut bracket
(1, figure A-1).
10 Place bracket (1, Figure A-2) over springnuts and secure using screws (3).
IMPORTANT
Observe the orientation of the “Key” slots used for mounting the CSAT
Transceiver. (Refer to Figure A-6.)
11 Loosely install four bolts (4, figure A-2), four flat washers (4), and four split
washers (6) into bolts hole located on the rear side of the unit.
12 Position unit against the bracket and hook the bolts into the key slots. Tighten bolts
to secure. (Refer to Figure A-8.)
Figure A-5. Installing the Pole Bracket
with CSAT Mounting Plate.