Comtech EF Data CSAT-5060 - Manual (Page 156)

C-Band Transceiver Revision 1
CSAT-5060 100/125 Watt Installation MN/CSAT5060.IOM
C–18
Step Procedures
8 Attach bracket (5, figure C-1) to the strap (4) using two nuts (10), two
flat washers, (7), and two splitlock washers (8).
9 Place the assembly against the pole with the strap around the pole and
trim the strap (4) to fit as shown in Figure C-16, using the tin snips.
10 Attach bracket (3, figure C-1) to the strap (4) using two nuts (10), two
flat washers (7), and two splitlock washers (8).
11 Slide tensioner bracket (2) into channel of the top Unistrut bracket (1).
12 Place assembly on the pole.
13 Slide bracket (3) over bracket (2).
14 Place flat washer (7) and splitlock washer (8), and nut (10) on
bracket (2).
15 Tighten nut to secure the tension strap.
16 Slide two springnuts, (5, figure C-2) into channel of the Unistrut
bracket (1, figure C-1).
17 Repeat procedure for second Unistrut bracket (1).
18 Install bracket (1, figure C-8) and secure to the Unistruts with four
bolts (11), lock washers (10), and flat washers.
19 Install switch mount bracket (8, figure C-8), to main bracket (1).
Secure with four bolts (11), lock washers (10), and nuts (9).
20 Ensure that the bracket is centered on the Unistruts. Tighten hardware.
IMPORTANT
When installed, ensure the CSAT fan is facing outward.
21 Install brackets (1, figure C-2) and secure to Unistrut brackets with
four bolts (6), flat washers (2) and split lock washers (3).
22 Position brackets (1) against center bracket. Do not tighten hardware
at this time.
23 Install four bolts (7, figure C-8) with split washers (10) , and flat
washers (2 ) into provided mounting holes in the CSAT 100-Watt
casting.
24 Carefully lift the unit, and slide the bolt head into the groove of
bracket (1, figure C-8).
25 Ensure the washers are between the unit and the bracket.
DO NOT tighten hardware at this time.
26 Temporarily install the assembled waveguide switch (Figure C-12).
27 Ensure that the ports line-up and can be secured. If a gap is present,
adjust by sliding the unit and bracket (1, figure C-2) on the Unistrut
(In or Out). (See Figure C-19)
28 Tighten hardware.