Comtech EF Data CSAT-5060 - Manual (Page 155)

C-Band Transceiver Revision 1
CSAT-5060 100/125 Watt Installation MN/CSAT5060.IOM
C–17
C.5.2.2 Assemble Redundant Configuration
Step Procedures
1 Place Unistrut bracket (1, Figure C-1) on a flat surface.
2 Slide two springnuts (9) into the channel of the Unistrut bracket.
3 Fasten two pipe blocks (11) loosely to the springnuts using two bolts (6),
two flat washers (7), and two splitlock washers (8). (See Figure C-17.)
4 Repeat procedure for second Unistrut bracket (1)
5 Position Unistrut bracket (1) with pipe blocks (11) against the mounting
pole, slide the pipe blocks (11) until they contact the mounting pole.
6 Ensure the pipe blocks (11) are centered to the Unistrut brackets (1).
7 Tighten the hardware.
Figure C-16. Pipe Blocks
Figure C-17. Looking down at Pipe Blocks