Comtech EF Data CSAT-5060 - Manual (Page 58)

C-Band Transceiver Revision 1
Remote Control MN/CSAT5060.IOM
6–6
• This response can only occur if the operator sends two or more ‘hardware
configuration’ type commands without allowing adequate time between
commands for the hardware to be configured.
Example: the operator issued commands to change both the Upconverter
frequency and the Downconverter frequency with less than 100
milliseconds between commands
•
If this response is returned the command has not been accepted and the operator
must resend the command.
6.2.1.5 Message Arguments
Arguments are not required for all messages. All arguments are ASCII codes for the
characters 0 to 9 (ASCII 48 to ASCII 57), period (ASCII 46) and comma (ASCII 44).
6.2.1.6 End Of Packet
Master to Slave: This is the Carriage Return character (ASCII code 13)
Slave to Master: This is the two-character sequence Carriage Return, Line Feed. (ASCII
code 13, and code 10.)
Both indicate the valid termination of a packet.
6.3 Commands or Responses
The commands and responses are provided to assist the technican in monitoring and
controlling the unit.