Basler Electric BE1-11m - Manual (Page 207)

9424200996 Rev L 195
BESTnet
™Plus
BE1-11m Motor Protection Systems with an Ethernet port have a web page interface that can be used to
view BE1-11m status, real-time data, demand data, faults, sequence of events, and power quality. Refer
to the
Communication chapter for information about configuring the BE1-11m to communicate through the
Ethernet port. Verify that Enable Web Pages is selected on the Settings, Communications, Ethernet
screen in the Settings Explorer of BESTCOMSPlus
® or on the Settings > Communication > Ethernet
screen of the front-panel display. Using a web browser, enter the IP Address of your BE1-11m in the
address bar. The protection system’s IP address is found on the front-panel display under Settings >
Communication > Ethernet. Figure 157 shows an example for a BE1-11m with an IP address of
10.0.129.101.
Figure 157. Address Bar of Web Browser
Status Page
Figure 158 illustrates the Status (home) page. Device information, firmware version, breaker status,
lockout status, motor status, alarm status, targets, local inputs status, and local outputs status are shown
on this page. A green indicator lights to indicate an energized state for inputs and outputs.
Figure 158. Status Page (Home Page)
Real Time Data
Figure 159 illustrates the Real Time Data page. Values for currents, frequency, voltages, and power are
shown on this page.
BE1-11m BESTnet
™Plus