Basler Electric BE1-11m - Manual (Page 160)

148 9424200996 Rev L
Table 60. Targets as Displayed
Target Description
27P-#-A/B/C Phase Undervoltage, A, B, or C
32-#-A/B/C/T-Over Power, Phase A, B, C, or Total, Overpower
32-#-A/B/C/T-Under Power, Phase A, B, C, or Total, Underpower
37-A/B/C Instantaneous Undercurrent
40Q Loss of Excitation, Reverse var Based
48 Incomplete Sequence
49RTD-# RTD-#-# Over/Undertemperature
49TC Thermal Curve
50-#-A/B/C Instantaneous Overcurrent, Phase A, B, or C
50-#-Residual Instantaneous Overcurrent, Residual
50-#-IND GND Instantaneous Overcurrent, Independent Ground
50-#-Pos SEQ Instantaneous Overcurrent, Positive-Sequence
50-#-Neg SEQ Instantaneous Overcurrent, Negative-Sequence
50-#-Unbalance Instantaneous Overcurrent, Unbalance
50BF Breaker Failure
51-#-A/B/C Inverse Overcurrent, Phase A, B, or C
51-#-Residual Inverse Overcurrent, Residual
51-#-IND GND Inverse Overcurrent, Independent Ground
51-#-Pos SEQ Inverse Overcurrent, Positive-Sequence
51-#-Neg SEQ Inverse Overcurrent, Negative-Sequence
51-#-Unbalance Inverse Overcurrent, Unbalance
55 Power Factor
59-#-A/B/C Phase Overvoltage, A, B, or C
59X-#-3V0 Auxiliary Overvoltage, 3V0-3ph VT
59X-#-V1 Auxiliary Overvoltage, Positive-Sequence
59X-#-V2 Auxiliary Overvoltage, Negative-Sequence
59X-#-AUX Auxiliary Overvoltage, Fundamental VX
59X-#-3RD Auxiliary Overvoltage, 3 rd Harmonic VX
60FL Fuse Loss Detection
62-# Timer Output
81-#-Over Frequency, Over
81-#-Under Frequency, Under
81-#-ROC Frequency, Rate of Change
86-# Lockout Function
87-A/B/C Differential Current, Phase A, B, or C
Analog In # Remote Analog Input
Target logging for a protective function can be disabled if the function is used in a supervisory or
monitoring capacity. The following paragraphs describe how the BE1-11m is programmed to define which
protective functions log targets.
Fault Reporting BE1-11m