Artesyn Centellis 4410 (AXP-1410) Installation and Use (July 2014) - Manual (Page 76)

System Installation
AXP 1410 Installation and Use (6806800H70L) 76
3.3.1 Installing the System in a Rack
The following procedure describes how to install the system in a rack.
Use power input cables with a cross section (minimum) of 21mm
2
, AWG 4.
Personal or System Damage
The system is heavy and if you carry it on your own you can hurt your back. To prevent injury,
keep your back straight and have two people to lift the system or use additional lifting
equipment.
Personal or System Damage
Unstable system installation in a rack can cause the rack to topple over.
Therefore, if your system is the only one in the rack, make sure to mount the system in the
lowest part of the rack. If other systems are installed in one rack, start with the heaviest
component at the bottom.
If the rack is equipped with stabilizing devices, make sure that they are installed and
extended so that the rack is secure. Then proceed to mount or service the system.