4 face plate, 5 leds, 4 face plate 8.5 leds – Artesyn Centellis 4410 (AXP-1410) Installation and Use (July 2014) User Manual
Page 195: Table 8-2, Face plate leds, Figure 8-2, Face plate
Shelf Management Alarm Module
AXP 1410 Installation and Use (6806800H70L)
195
8.4
Face Plate
The following figure highlights the position of connectors and LEDs on the face plate of the
board.
8.5
LEDs
The following LEDs can be found on the face plate of the board. The OOS, IS, ACT, and H/S LEDs
can be controlled via IPMI. Refer Supported Commands and FRU Information and Sensor Data
Records of SAM1410 Installation and Use manual, for further information. The Link and Activity
LEDs in the RJ45 connector are only controlled by the Ethernet PHY.
Figure 8-2
Face Plate
Table 8-2 Face Plate LEDs
LED
Color
Description
Failure (OOS) LED
Red
Red: The shelf manager board is out-of-service.
Off: The shelf manager board is working properly.
Active (ACT) LED
Amber
Amber: The shelf manager board is active.
Off: The shelf manager board is in standby mode.