Artesyn Centellis 4410 (AXP-1410) Installation and Use (July 2014) - Manual (Page 122)

Configuring and Operating the System
AXP 1410 Installation and Use (6806800H70L) 122
5.4.1 Installation
All system components are delivered with the software installed.
In case you need to reinstall the software on the ATCA-F120, an AMC module or a node blade,
you need to install the Basic Blade Services (BBS) Software as described in the respective Basic
Blade Services Software Programmer’s Reference. The BBS installation automatically installs all
necessary files. BBS images must be installed on hard disks or - for node blades and AMC
modules - the ATCA-F120 must have a boot image for the respective blade or AMC module.
5.4.2 Upgrade
The procedures and tools for software upgrades differ depending on what component needs
to be upgraded. Available tools for firmware upgrades are:
 FCU: part of BBS
 FUMI: part of HPI-B included in BBS
 fw_tool: integrated in the SAM1410 root file system
 swupgrade: integrated in the SAM1410 root file system
The following table shows which tools you can use and where you can find a description of how
to do it.
Artesyn Embedded Technologies recommends to always use FUMI if available.