Artesyn Centellis 4410 (AXP-1410) Installation and Use (July 2014) - Manual (Page 25)

Safety Notes
AXP 1410 Installation and Use (6806800H70L) 25
System Damage
The power inputs must only be attached to approved Telephone Network Voltage (TNV-2) or
Safety Extra Low Voltage (SELV) branch circuits.
Attaching inputs to non-TNV-2/SELV approved power sources will cause the system to fail
compliance with safety regulations.
Personal Injury or System Damage
The system is supplied by a TNV-2 voltage. This voltage is considered hazardous.
Make sure that the external power supply meets the relevant safety standards.
Personal Injury or System Damage
A top-heavy rack can tip, causing damage to equipment and injury to personnel.
If your system is the only one in the rack, make sure to mount the system in the lowest part of
the rack. If several systems are installed in one rack, start with the heaviest component at the
bottom. If the rack is equipped with stabilizing devices, make sure that they are installed and
extended so that the rack is secure. Then proceed to mount or service the system.
Personal Injury or System Damage
Avoid personal injury or system damage by preventing accidental dropping of the system.
Use the appropriate equipment to safely lift and mount the system.
Personal Injury
The system is heavy.
To avoid muscle strain or back injury use lifting aids and proper lifting techniques when
removing or replacing the system.
Operation
System Overheating
Cooling Vents
Improper cooling can lead to blade and system damage and may void the manufacturer’s
warranty.