Supported ipmi commands, 1 introduction, 2 standard ipmi commands – Artesyn Centellis 4410 (AXP-1410) Installation and Use (July 2014) User Manual
Page 141: 1 global ipmi commands, 2 event commands, 1 introduction 6.2 standard ipmi commands, 1 global ipmi commands 6.2.2 event commands, Table 6-1, Supported global ipmi commands, Table 6-2
Chapter 6
AXP 1410 Installation and Use (6806800H70L)
141
Supported IPMI Commands
6.1
Introduction
This chapter describes the different commands supported by the AXP 1410 series platforms.
Command categories are as follows:
6.2
Standard IPMI Commands
The IPMC is fully compliant to the Intelligent Platform Management Interface v.1.5. This
section provides information on which IPMI commands are supported on PEMs and fans. Table
entries marked with an “X” indicate which FRU supports a listed command. IPMI information
for blades can be found in the respective blade documentation.
6.2.1
Global IPMI Commands
The IPMC supports the following global IPMI commands.
6.2.2
Event Commands
The IPMC supports the following event commands.
Table 6-1 Supported Global IPMI Commands
NetFn Rq/Rs
Command
CMD
PEMs
FTMs
Get Device ID
0x06/0x07
0x01
X
X
Table 6-2 Supported Event Commands
Command
NetFn Rq/Rs
CMD
PEMs
FTMs
Set Event Receiver
0x04/0x05
0x00
X
X
Get Event Receiver
0x04/0x05
0x01
X
X