Artesyn Centellis 4410 (AXP-1410) Installation and Use (July 2014) - Manual (Page 121)

Configuring and Operating the System
AXP 1410 Installation and Use (6806800H70L) 121
5.4 Software
System components are delivered with the software installed.
Switch software Backplane ethernet
connections from other
blades 192.168.21.1 or 192.168.22.1 in slot 6
192.168.21.2 or 192.168.22.2 in slot 9
Out-of-band interface
on ATCA-F120 No default setting, IP address as
defined by user in uboot
Node blade software RTM-ATCA-F120 (after
RTM port configuration) Node blade IP addresses are assigned
by the DHCP server
DHCP server
configuration Backplane ethernet
connections from other
blades 192.168.21.1 or 192.168.22.1 in slot 6
192.168.21.2 or 192.168.22.2 in slot 9
Out-of-band interface on
ATCA-F120 No default setting, IP address as
defined by user in uboot
Table 5-4 Access to System Components
Component To Be
Configured and Accessed
Access Via Default IP Address
Table 5-5 Software Available on System Components
Component Software
SAM1410 IPMC firmware
Boot loader (Uboot)
Linux kernel
Initial ram disk
Fan trays IPMI firmware
Node blade Basic Blade Services Software including:

Operating System
 Hardware management functions
 Set of management routines for Linux and all hardware
interfaces
PEM IPMI firmware