beautypg.com

6 installing and removing the blade, Installing and removing the blade, Scribed in – Artesyn ATCA-7365 Installation and Use (November 2014) User Manual

Page 66

background image

Hardware Preparation and Installation

ATCA-7365 Installation and Use (6806800K65N)

66

The location of the USB 2.0 Flash Module is shown in

Figure "ATCA-7365 Blade Layout (Variants

with 10 DIMM sockets)" on page 56

.

Removal Procedure

To remove a USB flash module:

1. Remove the blade from the system as described in

Removing the Blade

on page 70

.

2. Remove the screw on the left side of the flash module (see figure

Figure 2-2 on

page 56

).

3. Lift the flash module from the socket.

Installation Procedure

To install a USB flash module:

1. Remove the blade from the system as described in

Removing the Blade

on page 70

.

2. Insert the new flash module in socket (see figure

Figure 2-2 on page 56

).

3. Tighten the screw on the left side of the flash module.

2.6

Installing and Removing the Blade

The blade is fully compatible with the AdvancedTCA standard and is designed to be used in
AdvancedTCA shelves.

Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten their life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.