Artesyn ATCA-7365 Installation and Use (November 2014) - Manual (Page 216)

Maps and Registers
ATCA-7365 Installation and Use (6806800K65N) 216
3:2 Reserved 0 LPC: r
4 TSOP or PLCC Boot select. Signal
BOOT_TSOP.
0: TSOP selected
1: PLCC selected Ext.
0: SW1.3 OFF
1: SW1.3 ON LPC: r
5 Manual Boot Flash select enable. Signal
BOOT_SEL_EN_.
0: Signal BOOT_SELECT selects active boot
flash
1: Switch SW3.2 selects the active Boot
Flash. Ext.
0: SW3.1 OFF
1: SW3.1 ON LPC: r
6 Manual Boot Flash select. Signal
BOOT_DEFAULT. Used when SW3.1 is ON:
0: Selects Default Boot SPI Flash.
1: Selects Recover Boot SPI Flash. Ext.
0: SW3.2 OFF
1: SW3.2 ON LPC: r
7 IPMC signal BOOT_SELECT. Boot Flash
Select.
0: Selects Default Boot SPI Flash
1: Selects Recovery Boot SPI Flash Ext. LPC: r
1. The default is latched from SW1.1 when ICH_PLTRST_ is de-asserted.
2. The default is latched from SW1.2 when ICH_PLTRST_ is de-asserted.
Table 6-64 Flash Status Register (continued)
Address Offset: 0x040
Bit Description Default Access