3 module identification register, 4 version register, 5 serial redirection control register – Artesyn ATCA-7365 Installation and Use (November 2014) User Manual
Page 198: Table 6-41, Module identification register, Table 6-42, Version register, Maps and registers
Maps and Registers
ATCA-7365 Installation and Use (6806800K65N)
198
Note: For LPC I/O address, 0x80 is used.
6.4.3
Module Identification Register
The Module Identification Register identifies the ATCA-7365 Blade (Wellbeck).
6.4.4
Version Register
The version register provides the version of the FPGA bit stream. The initial value starts at 0x01
and will be incremented with each new release.
6.4.5
Serial Redirection Control Register
BIOS set the corresponding bit, which is used for serial redirection. The IPMC uses this
information to route the corresponding port to serial IPMC interface in case of SOL.
Table 6-41 Module Identification Register
Address Offset: 0x00
Bit
Description
Default
Access
7:0
ATCA-7365 Blade (Wellbeck) Module Identification
0x60
r
Table 6-42 Version Register
Address Offset: 0x01
Bit
Description
Default
Access
7:0
Specifies FPGA version
1 (Initial
Value)
r
BIOS should never set both status bits.