Artesyn ATCA-7365 Installation and Use (November 2014) - Manual (Page 120)

BIOS
ATCA-7365 Installation and Use (6806800K65N) 120
4.5.3 IPMI
4.5.3.1 IPMI -> IPMI Watchdog Configuration
The following table contains information about the options available for IPMI Watchdog
Configuration.
Table 4-22 IPMI -> IPMI Watchdog Configuration
Item Values Description
POST Timer (FRB2) Enable,
Disable (Default) Enable or Disable FRB2 timer (POST timer).
This watchdog monitors BIOS initialization tasks.
FRB2 Timer
timeout 3, 4, 5, 6 minutes
Default 6 minutes Enter value between 3 to 6 minutes for FRB2 timer
expiration value.
Not available if FRB2 Timer is disabled.
FRB2 Timeout
Action Do Nothing,
Reset (Default),
Power Down
Power Cycle Configure how the system should respond if the FRB2
Timer expires.
Not available if FRB2 Timer is disabled.
O/S Watchdog
Timer Enable,
Disable (Default) If enabled, starts a BIOS timer just before booting the
OS. The OS has to shut off the watchdog timer when
successfully booted.
O/S Watchdog
Timer Timeout 1,2,3,5, 7, 10, 15, 20
minutes
Default 5 minutes Configure the time out of the O/S Boot Watchdog
Timer. Not available if O/S Boot is disabled.
O/S Watchdog
Timeout Action Do Nothing,
Reset (Default),
Power Down Configure how the system should respond if the O/S
Boot Watchdog Timer expires. Not available if O/S
Boot Watchdog Timer is disabled.