Artesyn ATCA-7365 Installation and Use (November 2014) - Manual (Page 21)

ATCA-7365 Installation and Use (6806800K65N) 21
About this Manual
Overview of Contents
This Reference Guide is intended for users qualified in electronics or electrical engineering.
Users must have a working understanding of Peripheral Component Interconnect (PCI),
AdvancedTCA®, and telecommunications.
The manual contains the following chapters and appendices:
 About this Manual on page 21 lists all conventions and abbreviations used in this manual
and outlines the revision history.
 Safety Notes on page 29 lists safety notes applicable to the blade.
 Sicherheitshinweise on page 33 provides the German translation of the safety notes section.
 Introduction on page 39 describes the main features of the blade.
 Hardware Preparation and Installation on page 49 outlines the installation requirements,
hardware accessories, switch settings, installation and removal procedures.
 Controls, Indicators, and Connectors on page 73 describes external interfaces of the blade.
This includes connectors and LEDs.
 BIOS on page 95 describes the features and setup of BIOS.
 Functional Description on page 153 describes the functional blocks of the blade in detail.
This includes a block diagram, description of the main components used and so on.
 Maps and Registers on page 165 provides information on the blade’s maps and registers.
 Serial Over LAN on page 229 provides information on how to establish a serial-over LAN
session on your blade.
 Supported IPMI Commands on page 235 lists all supported IPMI commands.
 FRU Information and Sensor Data Records on page 275 provides information on the blade’s
FRU information and sensor data.
 Firmware Upgrade on page 293 provides information on how to upgrade the firmware
components.
 Replacing the Battery on page 299 provides the battery exchange procedures.
 Related Documentation on page 303 provides links to further blade-related
documentation.