Artesyn ATCA-7365 Installation and Use (November 2014) - Manual (Page 122)

BIOS
ATCA-7365 Installation and Use (6806800K65N) 122
4.5.5 Boot
The following table contains information about the options available on Boot menu screen.
Target Name Enter the target name. Not available when DHCP is
enabled.
Target IP Address 0.0.0.0 IP address of the target device. Not available when
DHCP is enabled.
Target Port 0 Target Port. Not available when DHCP is enabled.
Boot LUN 0 Hexadecimal representation of the LUNumber.
Examples are: 4752-3A4F-6b7e-2F99, 6734-9-
156f-127, 4186-9. Not available when DHCP is
enabled.
CHAP Type None (Default),
One Way,
Mutual Select the CHAP (Challenge-Handshake
Authentication Protocol) type.
Save Changes Press Enter to save changes.
Back To Previous Page Press Enter to return to the previous page (same as
ESC).
Table 4-24 iSCSI (continued)
Item Values Description
Table 4-25 Boot
Item Values Description
Setup Prompt
Timeout 0..65535 seconds
Default 2 seconds Number of seconds to wait for setup activation key.
65535(0xFFFF) means indefinite waiting.
Bootup NumLock
State On/Off
Default on Select the keyboard NumLock state.
Interrupt 19 Capture Enable,
Disable (Default)
If enabled, allows Option ROMs to trap Int 19. This
is needed for some SCSI/SAS controller.
Boot Option Priorities Select the boot device order.