1 serial output commands, 1 set serial output command, Table 8-19 – Artesyn ATCA-7365 Installation and Use (November 2014) User Manual
Page 252: Serial output commands, Table 8-20, Request data of set serial output command, Serial, Output commands, Supported ipmi commands
Supported IPMI Commands
ATCA-7365 Installation and Use (6806800K65N)
252
8.3.1
Serial Output Commands
The following table provides description about the types of Serial Output Commands.
8.3.1.1
Set Serial Output Command
The Set Serial Output command selects the serial port output source for a serial port
connector.
8.3.1.1.1 Request Data
The following table lists the request data applicable to the Set Serial Output command.
Table 8-19 Serial Output Commands
Command Name
NetFn (Request/Response)
CMD
Description
Set Serial Output
0x2E/0x2F
0x15
Get Serial Output
0x2E/0x2F
0x16
Table 8-20 Request Data of Set Serial Output Command
Byte
Data Field
1
LSB of Artesyn Embedded Technologies IANA Enterprise number. A value of 0xCD has
to be used.
2
Second byte of Artesyn Embedded Technologies IANA Enterprise number. A value of
0x65 has to be used.
3
MSB of Artesyn Embedded Technologies IANA Enterprise number. A value of 0x00 has
to be used.
4
Serial connector type
0: Face plate connector
1: Backplane connector
All other values are reserved.
Note: Only the faceplate connector is supported. No connector on the RTM available.
5
Serial connector instance number. A sequential number that starts from "0".