Artesyn ATCA-7365 Installation and Use (November 2014) - Manual (Page 247)

Supported IPMI Commands
ATCA-7365 Installation and Use (6806800K65N) 247
usb USB support fp_on/fp_off,rtm_on/rtm_off,onboard_on/onboard_off
Example: usb=fp_off,rtm_off,onboard_on
-> Front panel USB off, RTM USB off, Onboard Flash USB
on
os_boot_watchd
og OS boot
Watchdog (IPMI) on/off,timout in minutes,action
Timeout range 1,2,3,5,7,10,15,20
action: noaction/reset/poweroff/powercycle
Example: os_boot_watchdog=on,10,reset
-> watchdog is on, 10 minutes timeout, action=reset
rtm_auto Auto detect RTM
If enabled (on), the
parameter for
'Force Gen1' and
RTM PCIe
configuration is
set correctly. on/off: auto detect on/off
gen1on/gen1off: Force Gen1 on/off
x4x4x4x4/x4x4x8/x8x4x4/x8x8/x16: PCIe bifurcation
Example: rtm_auto=off,gen1on,x4x4x8
-> RTM auto detect on, Force Gen1 on, PCIe x4x4x8
frontnet_boot Boot from Front
Panel Network off/on
basenet_boot Boot from Base
Network off/on
artm_net_boot Boot from ARTM
Network
off/on
artm_sas_boot Boot from ARTM
SAS device
off/on
artm_fc_boot Boot from ARTM
FC device off/on
boot_order Boot priority order
device1,devcice2,..device8
See
boot_order Devices
uefi# UEFI Media path Format: NAME=DevicePath
This paramter contains a UEFI Device path in text form.
This parameter is saved at boot time. The Installer from a
UEFI compatible OS writes this parameter to NVRAM and
after the next reboot
BIOS stores this to IPMI boot parameter
Table 8-15 System Boot Options Parameter #100 - Supported Parameters (continued)
Parameter Description Values