8 lan device commands, 2 picmg 3.0 commands, Table 8-17 – Artesyn ATCA-7365 Installation and Use (November 2014) User Manual
Page 249: Supported lan device commands, Table 8-18, Supported picmg 3.0 commands, Supported ipmi commands
Supported IPMI Commands
ATCA-7365 Installation and Use (6806800K65N)
249
8.1.8
LAN Device Commands
The following table provides details about LAN Device Commands.
8.2
PICMG 3.0 Commands
The Artesyn Embedded Technologies IPMC is a fully compliant AdvancedTCA intelligent
Platform Management Controller. It supports all required and mandatory AdvancedTCA
commands as defined in the PICMG 3.0 and AMC.0 R2.0 specifications.
Table 8-17 Supported LAN Device Commands
Command
NetFn (Request/Response)
CMD
Set LAN Configuration Parameters
0x0C/0x0D
0x01
Get LAN Configuration Parameters
0x0C/0x0D
0x02
Set SOL Configuration Parameters
0x0C/0x0D
0x21
Get SOL Configuration Parameters
0x0C/0x0D
0x22
Table 8-18 Supported PICMG 3.0 Commands
Command
NetFn
(Request/Response)
CMD
Comments
Get PICMG Properties
0x2C/0x2D
0x00
-
Get Address Info
0x2C/0x2D
0x01
-
FRU Control
0x2C/0x2D
0x04
The blade supports the
cold reset and graceful
reboot options.
Get FRU LED Properties
0x2C/0x2D
0x05
-
Get FRU LED Color Capabilities
0x2C/0x2D
0x06
-
Set FRU LED State
0x2C/0x2D
0x07
-
Get FRU LED State
0x2C/0x2D
0x08
-
Set IPMB State
0x2C/0x2D
0x09
-
Set FRU Activation Policy
0x2C/0x2D
0x0A
-
Get FRU Activation Policy
0x2C/0x2D
0x0B
-