AMETEK ReFlex Programming Manual - Manual (Page 86)

ReFlex Power™ Programming Manual DC Module Remote Programming
82 M380056-03 Rev M
3.15 LIST SCPI COMMANDS
Please see Section 3.12.1 for background and proper use of the List
commands.
3.15.1 LIST SCPI C OMMAND S UMMARY
LIST
:START “filename”
:END
:STORe
:DELETE “filename”
:CATalog?
:ABORT
:OPEN “filename”
:CLOSe
:ARM
:TAG
:TAG?
:STATUS?
:ERRor?
:LABEL<0-31>
:GOTO LABEL<0-31>
:LOOP , LABEL<0-31>
:DWELl <+NRf>
:TRIGger , WAIT
:RAMP
:CURR fIstart, fIend, ftSec
:VOLT fVstart, fVend, ftSec
:VOLTCURR fVstart, fVend, fIstart, fIend, ftSec
:CURR GE NRf, LABEL<0-31>
:CURR LT NRf, LABEL<0-31>
:VOLT GE NRf, LABEL<0-31>
:VOLT LT NRf, LABEL<0-31>
3.15.2 LIST SCPI C OMMAND R EFERENCE
Command Description
LIST LIST subsystem.
: START
1
Names the list in module n with . This must be the first
SCPI command in the LIST sequence
: END
Ends the list that was started by the LIST:START
command.
: STORe Save the list as , overwrite is allowed.
: DELETE
1
Deletes the saved list
: CATalog? Returns the LISTs currently saved in module .
: ABORT Stops a LIST operation, returns to the IDLE state.
: OPEN
1
Enables the saved list in module for execution.
This LIST can only be run; editing must be done in user space.