AMETEK ReFlex Programming Manual - Manual (Page 29)

Controller Module Remote Programming ReFlex Power™ Programming Manual
M380056-03 Rev L 25
If you are not sure you are connected to the correct Controller module, e.g.,
multiple Controller modules were listed in the LXI™ Discovery Browser, click
the SET button at the bottom of the HOME page (when clicked, the SET
button becomes the CLEAR button). SET causes that Controller module’s
LAN LED to blink for identification purposes. Click the CLEAR button to stop
the blinking (CLEAR button changes back to SET).
The HOME page has links (tabs) to three other pages in the ReFlex Power™
Interface: IP CONFIGURATION, SECURITY and MODULES. Also, in the
upper right area of the interface is the LOGIN button.
2.5.2 LOGIN S CREEN
Click the LOGIN button to log in; clicking the IP CONFIGURATION tab also
brings up the LOGIN page, but with an error message prompting you to log in
(Figure 2-5).
Figure 2-5. LOGIN Page with Authorization warning