AMETEK ReFlex Programming Manual - Manual (Page 133)

Fixed Power DC Remote Programming ReFlex Power™ Programming Manual
M380056-03 Rev L 129
6.7 STATUS COMMANDS
6.7.1 STATUS SCPI C OMMAND S UMMARY
STATus
:MODule
:ENABles <0+NR1>
:ENABles?
:FAULts?
:HWREV?
6.7.2 STATUS SCPI C OMMAND R EFERENCE
Command Description
STATus STATUS subsystem of commands..
:MODule
:ENABles<0+NR1>
Enable supervisory faults, see Table 6-2 . Same
Table describes Fault bits.
:ENABles? Query the enabled supervisories
:FAULts? Query the supervisory faults.
:HWREV? Returns Module type and Hardware Revision
Table 6-2. Fixed Power Faults and Enable Register
Bit Hex Value Mnemonics Description
0 0x00000001 P5VF Plus 5 Volt Fault
1 0x00000002 M5VF Minus 5 Volt Fault
2 0x00000004 P15VF Plus 15 Volt Fault
3 0x00000008 M15VF Minus 15 Volts Fault
4 0x00000010 OTP Over Temperature Fault
5 0x00000020 5VSNSF 5 Volt House Keeping Sense Fault
6 0x00000040 12VSNSF 12 Volt House Keeping Sense Fault
7 0x00000080 PWROKF Power Ok Fault
6.8 SYSTEM COMMANDS
6.8.1 SYSTEM SCPI C OMMAND S UMMARY
SYSTem
:ERRor?
6.8.2 SYSTEM SCPI C OMMAND R EFERENCE
Command Description
SYSTem SYSTEM subsystem of commands.
:ERRor? Returns the last error logged in the Error/Event Queue. The message,
“0, No error”, is returned if there are no errors.