beautypg.com

AMETEK ReFlex Programming Manual User Manual

Page 67

background image

DC Module Remote Programming

ReFlex Power™ Programming Manual

M380056-03 Rev L

63

3.9.2

SOURCE

SCPI

C

OMMAND

R

EFERENCE

Command

Description

SOURce

Source subsystem. Module ‘n’.

:CURRent

Sets the output current in amps.

:CURRent?

Query the set output current in amps.

:LIMit

Sets an upper soft limit on the programmed output current for
the supply.

:LIMit?

Query an upper soft limit on the programmed output current
for the supply.

:PROTection

Sets the overcurrent protection trip point in amps

:PROTection?

Query the overcurrent protection trip point in amps

:TRACKing

Set the over current protection to tracking. 1 means turn on
the tracking supervisory and 0 means turn off the tracking
supervisory

:TRACKing?

Query the tracking supervisory status.

:MODE?

Query, 1 is constant current mode, 0 is voltage mode. See
OUTP[n]:PROT:FOLD command.

:RAMP

See Table 3-9. For Software Ramps

:TRIGger

See Table 3-8. For Software Setpoints

:VOLTage

Sets the output voltage of the supply in volts. *See note at end
of this table.

:VOLTage?

Query the set point of the output voltage of the supply in volts.

:LIMit

Sets the upper soft limit on the programmed output voltage.

:LIMit?

Query an upper soft limit on the programmed output voltage.

:PROTection

Sets the overvoltage protection trip point in volts.

:PROTection?

Query the set point of the overvoltage protection trip point in
volts.

:TRACKing

Set the over voltage protection mode to tracking. 1 equals on,
and 0 turns off the tracking supervisory.

:TRACKing?

Query the tracking supervisory status.

:ENABle

Disable OVP when OFF, Save current setting, and set OVP to
factory maximum value. When ON, restore the saved OVP
setting.

:ENABle?

Query if OVP is Enabled or Disabled.

:RAMP

See Table 3-9. For Software Ramps

:TRIGger

See Table 3-8. For Software Setpoints

:UNDERVOLTage

:PROTection

Sets the undervoltage protection trip point in volts.

:PROTection?

Query the set point of the undervoltage protection trip point in
volts.

:TRACKing

Set under voltage protection tracking. 1 = On, 0= Off.

:TRACKing?

Query the tracking supervisory status.

:TRIPped?

Returns 1 if the supply has an undervoltage fault

*Note:

Set and Query the state of the polarity relay using the

OUTPut:POLarity

command.