AMETEK ReFlex Programming Manual - Manual (Page 124)

ReFlex Power™ Programming Manual Load Module Remote Programming
120 M380056-03 Rev L
Command Description
:DELAY
Set the power protection delay time in mSec.
The range for the delay is 1 to 100mSec.
Default delay time is 1mSec
Delay time takes effect as soon as the command is sent.
The Reset command sets the delay time to the default value.
:DELAY? Returns the value of the Power protection delay time.
5.10 STATUS SCPI COMMANDS
5.10.1 STATUS SCPI C OMMAND S UMMARY
STATus
:MODule
:ENABles <0+NR1>
:ENABles?
:FAULts?
5.10.2 STATUS SCPI C OMMAND R EFERENCE
Command Description
STATus STATUS subset of SCPI commands.
:MODule
:ENABles<0+NR1> Enable the supervisory see Table 5-2.
:ENABles? Query the enabled supervisories
:FAULts? Query the module faults