AMETEK ReFlex Programming Manual - Manual (Page 7)

Elgar ReFlex Power™ Contents
M380056-03 Rev L iii
Important Safety Instructions
Before applying power to the system, verify that your product is configured properly for your particular application.
WARNING
Hazardous voltages may be present when covers are removed. Qualified personnel
must use extreme caution when servicing this equipment. Circuit boards, test points,
and output voltages also may be floating above (below) chassis ground.
WARNING
The equipment used contains ESD sensitive parts. When installing equipment, follow
ESD Safety Procedures. Electrostatic discharges might cause damage to the
equipment.
Only qualified personnel who deal with attendant hazards in power supplies, are allowed to perform installation and
servicing.
Ensure that the AC power line ground is connected properly to the Power Rack input connector or chassis.
Similarly, other power ground lines including those to application and maintenance equipment must be grounded
properly for both personnel and equipment safety.
Always ensure that facility AC input power is de-energized prior to connecting or disconnecting any cable.
In normal operation, the operator does not have access to hazardous voltages within the chassis. However,
depending on the user’s application configuration, HIGH VOLTAGES HAZARDOUS TO HUMAN SAFETY may be
normally generated on the output terminals. The customer/user must ensure that the output power lines are labeled
properly as to the safety hazards and that any inadvertent contact with hazardous voltages is eliminated.
Guard against risks of electrical shock during open cover checks by not touching any portion of the electrical
circuits. Even when power is off, capacitors may retain an electrical charge. Use safety glasses during open cover
checks to avoid personal injury by any sudden component failure.
Neither AMETEK Programmable Power Inc., San Diego, California, USA, nor any of the subsidiary sales
organizations can accept any responsibility for personnel, material or inconsequential injury, loss or damage that
results from improper use of the equipment and accessories.
SAFETY SYMBOLS