AMETEK ReFlex Programming Manual - Manual (Page 130)

ReFlex Power™ Programming Manual Fixed Power DC Remote Programming
126 M380056-03 Rev L
6.5 CALIBRATION SCPI COMMANDS
CAUTION
Before attempting to execute any of the Fixed Power DC calibration commands, follow the
calibration procedures in the ReFlex Power™ Operation Manual (M380056-01), Fixed
Power DC Section. If calibration is not performed properly, functional problems could
arise, preventing the ReFlex Power™ Fixed Power DC supplies from operating properly
.
Qualified personnel who are appropriately trained to deal with attendant hazards must
perform calibration.
6.5.1 CALIBRATION SCPI C OMMAND S UMMARY
CALibrate
:UNLock
:STORe
:LOCK
:POSitive15 <0+NR1>
:POSitive15?
:POSitive5 <0+NR1>
:POSitive5?
:NEGative15 <0+NR1>
:NEGative15?
:NEGative5 <0+NR1>
:NEGative5?
:MODule:LASTCAL
:MODule:LASTCAL?
:MODule:NEXTTCAL
:MODule:NEXTCAL?