Calibration scpi commands – AMETEK ReFlex Programming Manual User Manual
Page 119
Load Module Remote Programming
ReFlex Power™ Programming Manual
M380056-03 Rev L
115
5.6
CALIBRATION SCPI COMMANDS
CAUTION
Before attempting to execute any of the Load calibration commands, follow the calibration
procedures in the ReFlex Power™ Operation Manual (M380056-01), Active Loads
Section. If calibration is not performed properly, functional problems could arise,
preventing the ReFlex Power™ Load(s) from operating properly
.
Qualified personnel who
are appropriately trained to deal with attendant hazards must perform calibration.
5.6.1
CALIBRATION
SCPI
C
OMMAND
S
UMMARY
CALibrate
:CALPOTS
:GAIN
:START
:CURRent
:CALCulate
:GAIN?
:OFFSet?
:INITial
:CURRent
:CURRent?
:CURRent
:PROTection
:PROTection?
:POWer
:PROTection
:PROTection?
:RESistance
:RESistance?
:STATE
:STATE?
:UNDERVOLTage
:PROTection
:PROTection?
:VOLTage
:PROTection
:PROTection?
:INPut
:CURRent
:COUNTS
:CALCulate
:FIVEPOINT <1-5>
:RANGE
:CURRent <1-2>
:CONDuctance
:COUNTS
:CALCulate