Remote programming overview, System level introduction, Features and functions – AMETEK ReFlex Programming Manual User Manual
Page 19: Reflex power™ ivi-com drivers

M380056-03 Rev M
15
1.
REMOTE PROGRAMMING OVERVIEW
1.1
SYSTEM LEVEL INTRODUCTION
This manual covers remote programming of the ReFlex Power™ system and
should be used in conjunction with the ReFlex Power™ Operation Manual,
M380056-01.This remote programming interface enables system operation
from a computer via Ethernet, allowing full remote programming control and
monitoring of all system modules, which include five basic types: the ReFlex
Power™ Controller (RFPC), AC, DC, Active Load (AL) and Fixed Power
modules. This programming manual is divided among sections addressing
each module type, beginning with the RFPC and its set up and connection
instructions for Ethernet control via SCPI commands. Set up includes
installing IVI-COM driver files, connecting the control computer with the
RFPC, and launching Ethernet and control communications. The remaining
module types are addressed in subsequent sections, each with their
applicable SCPI commands.
WARNING
Avoid personal injury or damage to any part of the system, observe all
electrical safety precautions described in the ReFlex Power™ operation
manuals when operating a ReFlex Power™ system. When developing a
program to control a ReFlex Power™ system, strictly adhere to connections
instructions and avoid contact with the power module outputs.
1.2
FEATURES AND FUNCTIONS
Features and functions are as follows:
•
SCPI compliant command set
•
Field-upgradeable firmware for all modules via Ethernet
•
System extensible up to eight Mainframes and ninety-six modules
•
Configuration flexibility
1.3
REFLEX POWER™ IVI-COM DRIVERS
This programming manual was not written for users who will develop
applications using the ReFlex Power™ IVI-COM (Interchangeable Virtual
Instrument Component Object Model) drivers. However, it is a good
supplement to help the developer understand the exact behavior of the