AMETEK ReFlex Programming Manual - Manual (Page 37)

Controller Module Remote Programming ReFlex Power™ Programming Manual
M380056-03 Rev L 33
2.6 LAUNCHING CONTROL COMMUNICATION
When the Ethernet interface is up and running, then start the communication
program as follows:
1. Copy the EnetTest.exe file supplied on the ReFlex Power™ CD-ROM into
any convenient directory on the control computer.
2. In its new location double-click the EnetTest.exe file.
This brings up the Elgar Net Test window (Figure 2-13) where the Host IP
and Port addresses must be set before control communication can begin.
Figure 2-13. Net Test Window
In the Host and Port fields of the Net Test window:
3. Enter the Host IP address acquired by the LXI™ Discovery Browser (Section
2.4.3), or the static IP address that you entered in the Ethernet Configuration
page (AutoIP will be in the range of 169.254.[1 thru 254].[0 thru 255].
4. Set the Port address to: 2340 (required)
5. Click the Connect button.